Free HP HPE6-A72 Study Guides Exam Questions and Answer
HPE6-A72 Exam Dumps, HPE6-A72 Practice Test Questions
Understanding functional and technical aspects of Aruba Certified Switching Associate (HP HPE6-A72) Professional Exam Design for Stacking
The following will be discussed in HP HPE6-A72 exam dumps:
- Vertical Switching Framework Arrangement
- Intro to Stacking technology
- Virtual System Extension Introduction
- Vertical Switching Framework member IDs and port numbers
- Tracking Layer 2 traffic: Multicast, and Unicast
- Describe how HPE storage solutions perform workload-balancing, creating a private, highly-available, intelligent storage cloud
- Vertical Switching Framework specifications
- Describe how HPE storage solutions use different platforms to integrate and create an intelligent end-to-end data availability and data protection solution
- Vertical Switching Framework Link
- Categorized Data Plane and Shared Link Aggregation
- Stacking Advantages
- Vertical Switching Framework Failover
- Vertical Switching Framework Link failure
- Centralized authority and administration plane
Aruba Networks Certified: Mobility Associate-Professional Exam Certified Professional salary
The estimated average salary of Aruba Certified Switching Associate (HP HPE6-A72) Professional Exam is listed below:
- India: 7,199,4 INR
- United States: 100,146 USD
- England: 71,460 POUND
- Europe: 88,032 EURO
These salaries are calculated at the time of writing according to the currency rates.
NEW QUESTION 16
Match the terms to the correct layer of the OSI model.
Answer:
Explanation:
NEW QUESTION 17
Match the terms to the correct layer of the OSI model.
Answer:
Explanation:
NEW QUESTION 18
Refer to the exhibit.
What VSF command produces the above output?
- A. show vsf link
- B. show vsf member
- C. show vsf detail
- D. show vsf topology
Answer: D
NEW QUESTION 19
Which statement is true regarding modern switching requirements?
- A. Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today's power-over-Ethernet needs.
- B. Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.
- C. Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.
- D. While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.
Answer: C
NEW QUESTION 20
Refer to the exhibit.
The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?
- A. The command terminal length 30
- B. The command page
- C. The command less
- D. The command more
Answer: B
NEW QUESTION 21
Core(config)# user admin password
Core(config)# interface mgmt
Core(config-if-mgmt)# ip static 10.254.16.89/22
Core(config-if-mgmt)# default-gateway 10.254.19.129
Core(config)# ssh server vrf mgmt
Core(config)# https-server vrf mgmt
You are tasked with configuring the Core switch to be managed by NetEdit. Currently, the Core switch is at factory-default settings.
Which two steps are missing? (Choose two.)
- A. Core(config)# https-server rest access-mode read-only
- B. Core(config-if-mgmt)# enable
- C. Core(config)# https-server rest access-mode read-write
- D. Core(config-if-mgmt)# no shutdown
- E. Core(config-if-mgmt)# no tftp-server
Answer: C,D
NEW QUESTION 22
Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)
- A. operates only in the 5GHz similar to 802.11ac
- B. operates in both the 2.4GHz and 5GHz radios bands
- C. is an emerging satellite connection standard to allow wireless access anywhere in the world
- D. is the first WLAN standard to no longer use electromagnetic signals to transmit data
- E. allows transmissions of up to 4.8Gbps
Answer: B,E
NEW QUESTION 23
Refer to the exhibit.
The above command was applied to an Aruba AOS-CX 6300M 24-port switch with 4-port SFP56 uplinks. All ports are set as access switchports.
Which ports carry VLAN 1 traffic?
- A. 1/1/8-1/1/10, 1/1/5-1/1/28
- B. 1/1/1-1/1/24
- C. 1/1/8, 1/1/10, 1/1/5-1/1/24
- D. 1/1/1-1/1/28
Answer: A
NEW QUESTION 24
Refer to the exhibit
What is true regarding VLAN 50 according to the diagram above?
- A. Since VLAN 50 has not been assigned to any enabled physical port, the status is down.
- B. VLAN 50 was never added to the vlan-database and therefore is in a down state.
- C. VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.
- D. VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.
Answer: A
NEW QUESTION 25
Match each network protocol to the correct default listening port and transport protocol. Not all answers will be used.
Answer:
Explanation:
NEW QUESTION 26
Refer to the exhibit.
You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.
What is a valid configuration for Access-2 to join the VSF stack?
- A. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - B. Access-2# configure
Access-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit Access-2(config)# vsf renumber-to 2 This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - C. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - D. Access-2# configure
Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2 2/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
Answer: A
NEW QUESTION 27
Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)
- A. operates only in the 5GHz similar to 802.11ac
- B. operates in both the 2.4GHz and 5GHz radios bands
- C. is an emerging satellite connection standard to allow wireless access anywhere in the world
- D. is the first WLAN standard to no longer use electromagnetic signals to transmit data
- E. allows transmissions of up to 4.8Gbps
Answer: B,E
Explanation:
Explanation/Reference:
NEW QUESTION 28
Which two types of routes can be found in the IP routing table of an Aruba AOS-CX switch? (Choose two.)
- A. Local
- B. RIPng
- C. ISIS
- D. BGP
- E. EIGRP
Answer: A,D
NEW QUESTION 29
Refer to the exhibit.
The above scenario shows a packet from the Server destined for the Firewall. Switch-A and Switch-B are bundled as VSF stack. The LAG between the VSF stack and the firewall indicates a hash function to forward the packet on port 2/1/2.
Which statement is true regarding how Switch-A will forward the packet?
- A. Switch-A will encapsulate the packet using GRE to forward to Switch-B in order for the packet to egress on port 2/1/2 per the hash function.
- B. Switch-A will drop the packet. Multi-Chassis lag to multi-chassis lag is not a supported feature of VSF.
- C. Switch-A will forward the packet along the VSF link to Switch-B so that it will egress on port 2/1/2 per the hash function.
- D. Switch-A will forward the packet on port 1/1/2. VSF will override the typical LAG hash function used for the physical interface selection.
Answer: C
NEW QUESTION 30
Which switch supports a maximum of 8 line-cards, 3 fabric modules, and 2 management cards?
- A. Aruba 6410
- B. Aruba 8400
- C. Aruba 5412r
- D. Aruba 8408
Answer: B
NEW QUESTION 31
......
Latest HPE6-A72 Actual Free Exam Questions Updated 90 Questions: https://quiztorrent.testbraindump.com/HPE6-A72-exam-prep.html
